Roland E-300 Manuel d'utilisateur télécharger pdf (Page 34)

Part 1

Make sure the blinking cursor is on "Y" and press the

[ENTER] key.

Selecting "Y" displays the following message.

Selecting "N" returns to the coordinate display (the

screen shown in step 1).

Make sure that “< >” appears.

1-12 Sending Cutting Data

* When set to “AUTO,” the machine automatically determines whether the mode 1 or mode 2 instruction system is used.

The EGX-300 performs cutting after receiving cutting data from the computer (application).

Data may be output, for example, after it has been created using any of a number of applications, or from driver.

In this section, general matters related to data output are explained. Refer to this section when carrying out data output. For details of the

cutting data output method, refer to the operation manual for the application software or driver used.

Do not operate beyond capacity or subject the tool to undue force.

The tool may break. If machining operation beyond capacity is started inadvertently, immediately press the

EMERGENCY STOP switch.

If the cover must be opened during cutting, first press the [ENTER/PAUSE] key to pause the EGX-300, then

open the cover. After the cover has been closed, cutting resumes when the paused state is canceled.

(The spindle will not rotate while the cover is open.)

NOTICE

Setting the Output device

Please select from among the models shown below when making the settings for output device with the application software.

Output Instruction Command setting Coordinate unit setting

model system on the EGX-300 on the EGX-300

EGX-300 CAMM-GL I AUTO 0.01 mm

PNC-2300A CAMM-GL I AUTO 0.01 mm

CAMM-2 Series CAMM-GL II AUTO 0.01 mm

CAMM-3 Series CAMM-GL I AUTO 0.01 mm

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 64 65

Pas de commentaire

Roland E-300 Manuel d'utilisateur Page 34