Roland E-300 Manuel d'utilisateur télécharger pdf (Page 31)

Part 1

Press the [ ] or [ ] key to set the feed rate.

Press the [ENTER] key.

The cutting-in amount is set by setting Z1.

Make sure that “< >” appears.

Setting range

X- and Y-axis : 0.5 to 60 mm/sec

Z-axis : 0.5 to 30 mm/sec

Spindle Motor Revolution Speed

Rotate the spindle control to set the speed of rotation.

Setting range: 5,000 to 15,000 rpm

* RPM : Revolutions Per Minute

LOW

5,000 rpm

When engraving work

piece material such as

acrylics that weakens

under heat high.

HIGH

15,000 rpm

When engraving work

piece material such as

aluminum or brass.

Cutting-in Amount

"1-11 Setting the Z1 and Z2 Position" means to set the Z1 point.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 64 65

Pas de commentaire

Roland E-300 Manuel d'utilisateur Page 31