Part 2
41
“I/O”
Default : AUTO
This sets the type of interface connected to the computer. When set to “AUTO,” the
interface type (parallel or serial) is determined automatically. However, serial communi-
cation parameters (baud rate, parity checking, stop bit, data bit, and handshaking settings)
are not determined and must be set.
I/O
“STOP”
Default : 1
This sets the number of stop bits when using a serial connection. Either 1 bit or 2 bits can
be selected.
“DATA”
Default : 8
This sets the data bit length when using a serial connection. A length of either 7 bits or 8
bits can be selected.
“PARITY”
Default : NONE
This makes the setting for parity checking when using a serial connection. The available
selections are no parity (“NONE”), even parity (“EVEN”), and odd parity (“ODD”).
“BAUDRATE”
Default : 9600
This sets the baud rate when using a serial connection. The available selections are 9600,
and 4800 bps.
“HANDSHAKE”
Default : HARD
This sets the handshaking mode when using a serial connection. Either hardwire (HARD)
handshaking or Xon/Xoff control can be selected.
Commentaires sur ces manuels