Roland E-300 Manuel d'utilisateur télécharger pdf (Page 40)

Part 2

Changing the Feed Rate or Spindle Speed During Cutting

The feed rate and spindle rotating speed set by the software can be changed while cutting is in progress.

This is done by first pausing the EGX-300 during cutting, then changing the feed rate. However, if the computer subsequently sends a

command to change the feed rate, the setting will change as specified by the new command. When set by software or set directly on the

EGX-300, the setting made last takes precedence.

Spindle speed can be changed at any time. Use the Spindle control to change it.

Changing the Feed Rate

Press the [ENTER/PAUSE] key while cutting is in

progress. One cutting step is performed, after which

operation stops. The display changes to show the

following message.

Press the [ ] or [ ] key to move the blinking cursor

(“ ”) to “XY-SPEED.”

To set the lowering speed of the head, move the

blinking cursor (“

”) to “Z-SPEED.”

Press the [MENU] key to make the following screen

appear on the display.

Press the [ ] or [ ] key to set the feed rate.

Setting range

X- and Y-axis : 0.5 to 60 mm/sec

Z-axis : 0.5 to 30 mm/sec

Press the [ENTER] key.

Make sure that

“< >” apears.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 64 65

Pas de commentaire

Roland E-300 Manuel d'utilisateur Page 40