Roland E-300 Manuel d'utilisateur télécharger pdf (Page 23)

Part 1

Loading Workpiece Using Commercially Double-sided Tape

Apply the double-sided tape to the bottom of the workpiece and secure it to the table.

Double-sided

tape

Workpiece

1-7 Loading a Cutter

Installing the Cutter holder and Collet

NOTICE

To install an end mill using the optionally available collet set (ZC-23), detach the blade holder. If you try to

perform machining with the blade holder installed, the vibration may make it come loose and fall off.

Be sure to use the wrench included with the unit. Using a wrench other than the included one may result in

overtightening, making it impossible to remove the collet or damaging the spindle.

Install a blade holder and collet that match the tool used.

When passing the tool through the holes in the cutter holder and

collet, the combination is suitable if it fits perfectly into the

hole.

Install the cutter holder and collet for the cutter to be used.

Head

Wrench

(

21 mm end of

the wrench

)

Wrench

(10 mm end of the wrench)

Collet

Cutter holder

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 64 65

Pas de commentaire

Roland E-300 Manuel d'utilisateur Page 23