Roland MC-4 Manuel du propriétaire télécharger pdf (Page 147)

147

Expanding the Memory

Appendices

Paying attention to the location of the notch on the memory

module and the orientation, insert it vertically within the guides

at either side of the socket.

fig.DIMM-02

If you have difficulty inserting the memory module, try tilting it a bit

and inserting one end at a time.

Move the white clips upward, and press them until the memory

module is locked in place.

fig.DIMM-03

Use the screws that you removed in step

to fasten the cover

back in place.

Removing the Memory

To remove the memory module, reverse the installation procedure.

Simultaneously press outward the white clips located at either

end of the socket.

fig.DIMM-04

Remove the memory module from the socket.

Checking that memory is

installed correctly

Turn on the power as described in “Turning On/Off the Power”

(p. 16).

Press [MENU].

Use [CURSOR] to select [System].

Press [ENTER] to access the System Menu screen.

fig.6-02

Press [F6 (System Info)].

Press [F2 (Memory Info)].

Verify that the screen correctly shows the amount of

memory you installed.

Press [F6 (Close)] to return to the System Menu screen.

Press [EXIT] to exit the System Menu screen.

* If the correct amount of memory is not shown, it is possible

that the memory is not being recognized properly. Turn off the

power as described in “Turning On/Off the Power” (p. 16),

and re-install the memory correctly.

Specifications of the expansion memory

(DIMM) that can be used

Number of pins: 168-pin

Speed: 100 MHz (PC100 CL=2)

133 MHz (PC133 CL=3)

Voltage: 3.3 V

Capacity: 128 MB

256 MB

Board height: 38 mm or less

The MC-909 has been confirmed to work with standard

memory that meets the above specifications. However, we

cannot guarantee that all memory of these specifications will

work correctly. Please be aware that even with identical

specifications, differences in the design of the memory

module or the conditions of use may mean that a memory

module may not be usable.

MC-909_Ref_e.book 147 ページ２００５年６月２８日　火曜日　午後２時５３分

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 179 180

Commentaires sur ces manuels

Pas de commentaire

Roland MC-4 Manuel du propriétaire Page 147

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel d'enregistrement Roland MC-4