Roland MC-4 Manuel du propriétaire télécharger pdf (Page 113)

113

Sampling procedure

Sampling

In the Volume section of the panel, use [INPUT] to

adjust the input level of the external source.

* If the input level is excessive, the word “CLIP” will appear at the

lower right of the level meter in the screen, and the CLIP indicator at

the upper right of the meter will light.

* Using a connection cable that contains a resistor can cause the sound

level to be low. Use a connection cable that does not contain a resistor.

* The level meter shows the level after the signal has passed through the

effects (compressor, multi-effects, reverb) and the mastering effect. If

you want to see the actual input level, turn off all effects and the

mastering effect (p. 88, p. 108).

(During Solo sampling, effects cannot be applied to the external input

sound.)

Press [F6 (Start)] to begin sampling.

You cannot save a sample that is larger than 128 MB

(approximately 24 minutes of monaural or 12 minutes of stereo).

If you are not using a memory card, you cannot save a sample that is

larger than 16 MB (approximately 180 seconds of monaural or 90

seconds of stereo).

* Even if you expand the memory (DIMM), you cannot save a sample

that is larger than 128 MB. (However, you can play it.)

Press [F5 (Stop)] to stop sampling.

The Sample Edit (p. 114) screen will appear.

fig.5-04

Press [EXIT] to go back to where you were before

you entered the Sampling screen.

Dividing a sample during

sampling

During sampling, press [F6 (Divide)].

The sample will be divided at the point where you pressed the

button, and the subsequent material will be sampled as a

sample of the next number.

* When sampling in mono, you can divide the material into a maximum

of 256 samples. When sampling in stereo, you can divide the material

into a maximum of 128 samples (L/R total 256 samples).

Samples that you load can be used in patches or rhythm sets

in the same way as waves.

Samples that you load will be lost when you turn off the power. If

you want to keep them, you must Save them (p. 123).

About the volume when resampling

The volume of a phrase that you resample may be less than the

volume of the original phrase. If necessary, execute the Normalize

command (p. 121) to raise the volume.

Sampling

Length

When Stop Trigger is BEAT

1–20000

Number of beats to contin-

ue sampling

When Stop Trigger is TIME

00’00”010–

50’00”000

length of time to continue

sampling

The maximum value will depend on the amount

of memory.

* This parameter cannot be specified if Stop Trig-

ger is set to MANUAL.

Auto Trig-

ger Level

0–7 Volume level at which

sampling will begin when

Auto Trig is ON

A setting of 0 is the min-

imum.

Gap Time 500, 1000, 1500,

2000 ms

Length of silence at which

the sample will be divided

Whenever there is a si-

lent region longer than

the specified time, the

sample will be divided

at that point, and the

next sample number will

be assigned to the sound

that follows.

* This parameter is valid

only when you are using

Auto Divide Sampling.

Parameter

Range Explanation

Cautions when using a microphone

Howling could be produced depending on the location of

microphones relative to speakers. This can be remedied by:

1. Changing the orientation of the microphone(s).

2. Relocating microphone(s) at a greater distance from

speakers.

3. Lowering volume levels.

* If you use a microphone, connect the ground terminal to an

electrical ground (p. 15).

About the sample numbers chosen during

sampling

The samples created when you execute the sampling operation

are placed in an area where there are at least 256 consecutive

unused numbers in the sample list.

* You cannot perform sampling if there are not at least 256

consecutive unused numbers in the sample list. You will need to

delete unneeded samples (p. 124) in order to allocate 256 or more

consecutive free numbers.

MC-909_Ref_e.book 113 ページ２００５年６月２８日　火曜日　午後２時５３分

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 179 180

Commentaires sur ces manuels

Pas de commentaire

Roland MC-4 Manuel du propriétaire Page 113

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel d'enregistrement Roland MC-4