Roland V-Synth GT Manuel d'utilisateur télécharger pdf (Page 189)

189

Sample Mode

By specifying the Depth, you can automatically detect and “

▼

”mark locations where there is a strong attack (i.e.,

locations where the volume changes abruptly). Such marked locations are called events.

fig.04-22

Automatically Detecting Events

Parameter

Value Description

Depth (Encode Depth)

0–127

In the Sample Encode screen, move the cursor to “Depth” and set the value.

The higher the value you set, the more events will be assigned.

If the Playback Mode (p. 99) is “STEP,” the sample will play to the next

event, and then stop each time you play the key. When the Playback Mode

is set to “EVENT,” the sample will be divided at event locations, and

assigned to each key.

• If you set Depth to a high value, a large number of events may

be detected. If you encode in such a state, the interval

between events will be too short, and the expected result will

not be obtained when you play back in event units.

• If you change the location of an event after encoding, you

must re-encode the sample. When you encode, the newly

detected event locations will take effect.

V-Synth-GT_e.book 189 ページ２００７年４月９日　月曜日　午後１時４６分

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 247 248

Pas de commentaire

Roland V-Synth GT Manuel d'utilisateur Page 189