Roland V-Synth GT Manuel d'utilisateur télécharger pdf (Page 207)

207

System Mode (Settings Common to All Modes)

fig.08-18.eps_50

Pedal

Parameter

Value Description

Hold Polarity

(Hold Pedal Polarity)

Standard, Reverse

Selects the polarity of the Hold pedal. On some pedals,

the electrical signal output by the pedal when it is pressed

or released is the opposite of other pedals. If your pedal

has an effect opposite of what you expect, set this param-

eter to “Reverse.” If you are using a Roland pedal (that

has no polarity switch), set this parameter to “Standard.”

Pedal 1, 2 Assign

This specifies the function of each

pedal connected to the CTRL 1,

CTRL 2 PEDAL jacks.

OFF The control pedal will not be used.

CC01–31, 33–95 Controller numbers 1–31, 33–95

BEND UP Pitch bend (positive direction)

BEND DOWN Pitch bend (negative direction)

AFT Aftertouch

VALUE INC The pedal will perform the same operation as pressing

[INC/+]. This is convenient when you want to switch

patches or tones while performing.

VALUE DEC The pedal will perform the same operation as pressing

[DEC/-]. This is convenient when you want to switch

patches or tones while performing.

Pedal 1, 2 Polarity

Standard, Reverse

Selects the polarity of the pedal. On some pedals, the

electrical signal output by the pedal when it is pressed or

released is the opposite of other pedals. If your pedal has

an effect opposite of what you expect, set this parameter

to “Reverse.” If you are using a Roland pedal (that has no

polarity switch), set this parameter to “Standard.”

V-Synth-GT_e.book 207 ページ２００７年４月９日　月曜日　午後１時４６分

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 247 248

Pas de commentaire

Roland V-Synth GT Manuel d'utilisateur Page 207