Roland V-Synth GT Manuel d'utilisateur télécharger pdf (Page 144)

144

Editing a Tone (Pro Edit)

fig.06b-80.eps

Multi Step Modulator

Parameter

Value Description

Multi Step Modulator Switch

* This setting applies to all tracks

(Track A–D).

OFF, ON This turns the multi step modulator on/off.

Step Indicator

This indicates the current location within the step sequence.

Step Bar

This graphically shows the sixteen steps. The step bar shown at the far right

(number 17) is the same as the one that appears at the far left (number 1).

This is helpful when you’re setting up a looping sequence.

If you touch < SMOOTH >, the graph will become a (smooth) line graph.

If you touch < STEP >, the graph will become a bar graph.

Step knobs

Use these knobs to input the sixteen steps.

The V-Synth GT’s E1–E8 knobs correspond to knobs 1–8 and 9–16. To

switch between 1–8 and 9–16, hold down [SHIFT] and use [ ] [ ]

(the frame in the screen will move). According to how you turn the knob,

the effect will be shown as a graph of 1--16 steps, and the color will

change.

fig.06b-85.eps

When the cursor is at a step knob, you can hold down [SHIFT] and turn

the VALUE dial to simultaneously modify the value of all steps.

Key Sync

(Step Modulator Key Sync)

* This setting applies to all tracks

(Track A–D).

Off The step sequence will not be reset when a note-on occurs.

Part The step sequence will be reset when a note-on occurs, but will not be reset

if the key was played legato.

Voice The step sequence will be reset each time a note-on occurs.

Step Indicator

Step Bar

Multi Step Modulator Switch

V-Synth-GT_e.book 144 ページ２００７年４月９日　月曜日　午後１時４６分

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 247 248

Pas de commentaire

Roland V-Synth GT Manuel d'utilisateur Page 144