Roland V-Synth GT Manuel d'utilisateur télécharger pdf (Page 31)

Overview of the V-Synth GT

Project

The largest unit of memory used by the V-Synth GT is the project. A project contains up to 512 patches, up to 896

tones, up to 999 waves, and various system settings.

The V-Synth GT uses one project at a time.

Internal Memory

The V-Synth GT has internal memory that stores a project. When the V-Synth GT is shipped from the factory, this memory

already contains patch and wave data, but you are free to overwrite any of this. You can always restore the memory

to the factory-set contents (Factory Reset, p. 235).

Temporary Area

When you switch on the V-Synth GT’s power or load a project, the project data is located in an area of memory called

the temporary area.

Operations such as sampling or patch editing will affect the data in the temporary area.

If you simply turn off the power, the edited sample data or patch data will be lost; you must be sure to save it (using

SAVE/WRITE) if you want to keep it.

USB Memory

Internal memory can hold only one project, but you can use commercially available USB memory to store additional

projects.

USB Storage

If you connect the V-Synth GT to your computer via a USB cable, projects, patches, tones, and wave data in the V-Synth

GT’s internal memory can be saved (backed up) to the hard disk or other media on your computer (p. 221).

In addition, wave data created on the V-Synth GT can also be used by software running on your computer, or wave

data created by your computer software can be used on the V-Synth GT.

Sampling Memory

The amount of memory you can use for sampling will depend on the state of the project that is currently loaded into

the temporary area. With the factory-set project, there is approximately 69 seconds (stereo) / 138 seconds (monaural)

of sampling memory. If you delete the factory-set waves, you will be able to use a maximum of approximately 380

seconds (stereo) / 760 seconds (monaural) of sampling memory. However since a maximum of approximately 290

seconds (stereo) / 580 seconds (monaural) can be saved in internal memory, you will need to use a commercially

available USB memory if you want to store more samples than this.

* The above values are for when the sample is encoded using the “LITE” type (p. 188).

The factory-set waves can be restored using the Factory Reset operation (p. 235) even if they have been erased.

Factory Data

The factory data is an area of memory that stores the state of internal memory when the V-Synth GT is shipped from

the factory. If you’ve erased the factory-set patch or wave data from internal memory, but decide that you would like

to use it again, you can execute the Factory Reset procedure to bring this data back.

V-Synth-GT_e.book 31 ページ２００７年４月９日　月曜日　午後１時４６分

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 247 248

Pas de commentaire

Roland V-Synth GT Manuel d'utilisateur Page 31