Roland V-Synth GT Manuel d'utilisateur télécharger pdf (Page 17)

Getting Ready

Since the V-Synth GT contains no amplifier or speakers, you’ll need to connect it to audio equipment such as a

keyboard amplifier, monitor speaker system or home stereo, or use headphones to hear its sound.

921

To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the

power on all devices before making any connections.

926a

When connection cables with resistors are used, the volume level of equipment connected to the INPUT jacks may be

low. If this happens, use connection cables that do not contain resistors.

Before hooking anything up, make sure that the power on all of your gear is turned OFF.

Connect the V-Synth GT to your amp/speaker system as shown in the diagram.

fig.01b-001-e.eps

Use audio cables to connect audio equipment such as an amp or speakers. If you’re using headphones, plug them

into the PHONES jack.

Audio cables are not included with the V-Synth GT. You’ll need to provide them.

In order to fully experience the V-Synth GT’s sound, we recommend using a stereo amp/speaker system. If you’re

using a mono system, however, make your connections to the V-Synth GT’s MAIN OUT jack L/MONO.

Connecting an Amp and Speaker System

Monitor Speakers

(powered)

Power Amplifier

Mixer etc.

Stereo Headphones

V-Synth-GT_e.book 17 ページ２００７年４月９日　月曜日　午後１時４６分

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 247 248

Pas de commentaire

Roland V-Synth GT Manuel d'utilisateur Page 17