Roland GT-PRO Manuel du propriétaire télécharger pdf (Page 133)

133

Driver installation and settings (Macintosh)

FreeMIDI settings

Before connecting the USB cable, switch the GT-PRO’s driver mode to “Advanced.”

For instructions on switching the GT-PRO’s driver modes, refer to “Switching the Driver

Mode” (p. 88).

With the power switch turned OFF, use the USB cable to connect the GT-PRO to your

computer.

Make sure that the GT-PRO’s OUTPUT MAIN and SUB knobs are set to the lowest setting,

then switch ON the POWER switch.

Open the FreeMIDI Applications folder, and double-click the FreeMIDI Setup icon.

fig.12-0300

* The first time FreeMIDI is started up, a “Welcome to FreeMIDI!” dialog box will appear.

Click [Continue]. If this is the second or later time, select the FreeMIDI Preferences from the File

menu.

fig.12-0310

* When “OMS is installed on this computer...” appears, click [FreeMIDI].

Make sure that Use OMS when available is unchecked in the FreeMIDI Preferences dialog

box.

If it is checked, remove the check mark, and restart FreeMIDI.

In the FreeMIDI Preferences dialog box, check GT-PRO Port which is located below GT-PRO

Driver in MIDI Configuration, and click [OK].

fig.12-0320

* If the dialog box does not show “GT-PRO Driver,” check whether the GT-PRO is connected correctly,

and start up FreeMIDI Setup once again.

The About Quick Setup dialog box will appear.

fig.12-0330

* If the dialog will not appear, select Quick Setup from the Configuration menu.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 163 164

Pas de commentaire

Roland GT-PRO Manuel du propriétaire Page 133