Roland CM-500 Manuel d'utilisateur télécharger pdf (Page 34)

8 Display Menu Lists

This chart lists the menus of the CM-500/400/300 grouped by usage. Menus indicated by an Circle (" ") are explained further in the

section at the end of the chart. Please refer to these additional explanations when using such menus.

MENU Explanation Default

Determining the type of sheet loaded

SELECT SHEET

This selects the type of material to be used ("ROLL," "EDGE," or "PIECE").

Setting cutting conditions

1—8

It is possible to set the cutting parameters (plotting parameters) to match the tool

and material (pen and paper condition), and store them for later use. Five items can

be stored: cutting speed , blade compensation, blade force, tool movement speed

during tool-up, and CUT QUALITY. These settings can be stored in memory as

eight patterns (numbered 1 through 8).

** cm/s

This sets the speed blade for during cutting. Perform a cutting test and set the

conditions to match the loaded material and the installed cutter.

50 cm/sec.

*.**mm

This sets the amount of offset for the blade during cutting. Perform a cutting test

and set the conditions to match the loaded material and the installed cutter. When

using the included test material and blade or equivalent parts, cutting can be

performed using the factory-default settings.

0.250 mm

**gf

This sets the force for the blade during cutting. Perform a cutting test and set the

conditions to match the loaded material and the installed cutter.

50 gf

SMOOTHING

If you want the curves of circles and arcs to be cut smoothly, set this to “ON.”

When on, however, small text or intricate designs may also be cut with rounded

corners. If this happens, change the setting to “OFF” and perform cutting again.

NORMAL

(CUT QUALITY)

This sets the cutting quality. Ordinarily this is left set to "NORMAL." When rapid

cutting is desired, such as when cutting a large material, set this to "HI-SPEED."

When load is large, or if the material is not cut smoothly, or when small text is to

be cut attractively, set this to "HEAVY."

NORMAL

This sets the speed of movement when the tool is raised and moves to the next

position for cutting during a cutting operation.

50 cm/s

OVER CUT

OFF

Setting the origin point

ORIGIN SET

Set a user origin at an arbitrary point on the material.

After the material has been loaded, be sure to set the origin to the bottom left of the

material.

Rotating the origin point

AXIS ROTATION

This rotates the cutting coordinate origin by 90 degrees. This is normally set to

“0deg,” which means that the origin is at the bottom left of the material. Setting

this to “90deg” moves the origin to the bottom right of the material, thereby

rotating the cutting pattern by 90 degrees.

* Don’t forget that the coordinate axis changes when the origin is rotated.

0deg

This cuts an excess margin of 1 mm (1/16") from the first and last line segments.

This selection is normally left set to "OFF," and is set to "ON" when cutting

especially attractive corners is desired. When cutting small text or intricate

graphics, however, this should be set to "OFF" to avoid cutting into the material.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Roland CM-500 Manuel d'utilisateur Page 34

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel d'enregistrement Roland CM-500