Roland CM-500 Manuel d'utilisateur télécharger pdf (Page 13)

3-3 Selecting the Interface

Close the front cover and press the

key.

The menu shown at right appears on the display.

Select [Auto] and press the

ENTER

key.

Next, the menu at right appears.

If connected with a serial (RS-232C) cable, make the settings to match the communi-

cation parameters for the host computer or program. (Take a look at "7 Display

Menus Flowchart.") If connected with a parallel (printer) cable, no settings are

needed here.

Press

PROTOCOL 1

STOP DATA PARITY

PROTOCOL 2

BAUD HANDSHAKE

Press

CROPMARK UPDOWN

OVER-CUT CALIB

VS-CMND FS-CMND

COMMAND I/O

Use or to select.

Press

ENTER

Use or to select.

Press

ENTER

INTERFACE

PARA SERI<AUTO>

AREA AXIS

REPLOT SUBMENU

Use or to select.

Press

ENTER

Use the and keys to move the blinking cursor to “SUBMENU” and press

ENTER

key.

Use the and keys to move the blinking cursor to “I/O” and press

ENTER

key.

Press the

key.

Make sure the settings for the computer (driver) match the settings for the CM-500/400/300 interface.

The selected interface type and communication parameters are stored in memory even after the power is switched off.

To change the interface type or the communication parameters, configurations must be re-entered.

* The CM-500/400/300 is equipped with an auto-interface function, and so

when left set to “AUTO,” it will automatically determine whether a parallel or

serial connection is used.

* If the communication parameters for the computer and the CM-500/400/300

are not identical, the cutting data cannot be received correctly, which may

result in faulty operation.

3-4 About the Driver

If you're using a program for Windows

95, install the "CAMM-1 DRIVER for Windows

95" included with the unit.

For more information about the installation and setup of the CAMM-1 DRIVER for Windows

95, please see the Readme.txt file.

This file is found on the driver disk.

To leave a submenu, choose [END] in the menu shown at right, and press the

ENTER

key.

SMOOTHING END

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Roland CM-500 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel d'enregistrement Roland CM-500