Roland CM-500 Manuel d'utilisateur télécharger pdf (Page 17)

Loading Roll Material

* When performing lengthy cutting of 1.5 m (60") or more, please refer to the section " To

Perform Lengthy Cutting" that follows this one.

Place the rolled material on the shaft.

Lower the sheet loading levers and raise the pinch rollers.

Pass the end of the material between the pinch rollers and

the grit rollers so that it extends from the front of the unit.

Sheet hanger

Stopper

Shafts

For information on how to install the sheet hanger, shaft, brake, and stoppers, please refer to the assembly manual for the PNS-500/

400/300 (the stand for the CM-500/400/300).

Mount the shaft at the location on the sheet hanger shown in the figure to match the outer diameter of

the rolled material.

When using a thick roll of

material

When only a small amount

of material remains (mate-

rial diameter is 72 mm (2-7/

8") or less)...

Shafts

No good

ShaftsShafts

Sheet hanger

To cut off a piece of material with the separating knife, load the media within the range shown below.

Loading media outside this range may make it impossible to cut off the material with the separating knife.

Separable range

13 mm (1/2") from the edge

of the leftmost grit roller

37 mm (1-7/16") from the edge

of the Rightmost grit roller

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

Pas de commentaire

Roland CM-500 Manuel d'utilisateur Page 17