Roland CM-500 Manuel d'utilisateur télécharger pdf (Page 20)

To Perform Lengthy Cutting

NOTICE

When performing material feed or cutting, be sure to release the brake.

Attempting to perform material feed or cutting with the brake engaged may make normal feed impossible and

cause the material to slip.

Have on hand a piece of material that's at least 50 mm (2") wider than the cutting width.

The chance of the material slipping loose from the pinch rollers can be reduced by braking the shaft and loading the pulled-out

material while it's in a tensioned state. Follow the steps below to load the material.

Place the rolled material on the shaft and engage the

brake for the shaft.

Pull out the material from the roll and pass it through

the unit.

Position the left- and right-hand pinch rollers as shown in the figure.

Position the middle pinch roller over the grit roller that lies between the left- and right-hand pinch rollers.

Position the stoppers so that they lightly touch the

edges of the roll, and secure in place by tightening the

screws.

Screws

Lift the sheet loading lever.

The pinch rollers are lowered and the material is

secured in place.

When using a material which is narrower than 762 mm

(30"), do not lower the pinch rollers.

Release the shaft brake.

Lift the sheet

loading levers

Roll material

Brake

Guide lines

25 mm

(1")

or more

25 mm

(1")

or more

Brake

(It should be fixed at inner

plane of sheet hanger.)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Pas de commentaire

Roland CM-500 Manuel d'utilisateur Page 20