Roland CM-500 Manuel d'utilisateur télécharger pdf (Page 25)

Incorrect cutting conditions may cause symptoms such as those described below.

For Materials with a Strong Adhesive Layer

If you are using a material with a strong adhesive layer, the adhesive layer may adhere to itself immediately when cut. This means that even

though the material has actually been cut, it may appear as if it has not been cut, and blade force may mistakenly be set too high.

If a cutting test shows that the material peels easily and the blade traces on the carrier paper are optimal, then the material is being cut.

Take care not to set the blade force excessively high.

Blade force Blade offset

Corners flare outward,

with "horns."

Corners are rounded.

Some parts of the sheet remain uncut.

• The sheet is easily torn.

• The cutter requires frequency replacement.

• Cutting extends through the base paper, and normal advancing

of the sheet becomes impossible.

• The unit suffers damage.

Too large

Too small

Too large

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 49 50

Pas de commentaire

Roland CM-500 Manuel d'utilisateur Page 25