Roland CM-500 Spécifications télécharger pdf (Page 51)

4. Perform cutting.

First use the alignment tool to line up the tip of the alignment tool with the leading edge of the crop marks, then send the cutting data.

Follow the same procedure to perform alignment for

mark 3 (and if the [4-POINT START] setting is

selected, for mark 4 as well).

When you've finished performing alignment for mark

3 (or mark 4), press the [ENTER] key to display the

screen shown in the figure.

Remove the alignment tool and install the blade

holder.

* If for some reason you want to go back to an earlier

step in these settings, such as to redo alignment,

pressing the [MENU] key displays the previous

screen, where you can redo the settings.

Press the [ ] key.

Use the [

] and [ ] keys to select either [4-POINT

START] or [3-POINT START], then press the

[ENTER] key. For four crop marks, select [4-POINT

START]. For three crop marks, select [3-POINT

START].

The screen shown in the figure appears.

Make sure the alignment tool is mounted, then press

the [ENTER] key.

The tool moves to stop near the lower-left crop mark (

mark 1), and the screen shown in the figure appears.

Using the cursor keys, align the tip of the alignment

tool with the crop mark.

With your finger, press down lightly on the alignment

tool to make sure its tip lies over the crop mark.

Press the [ENTER] key.

The tool moves to near the lower-right crop mark

(mark 2) and the screen shown in the figure appears.

In the same way as for mark 1, align the tip of the

alignment tool with the crop mark, then press the

[ENTER] key.

The tool moves to near the upper-left crop mark (mark

3) and the screen shown in the figure appears.

MANUAL

4-POINT START

REPLACE WITH TOOL

(QUIT MENU)

SET MARK 1

(RETURN MENU)

SET MARK 2

(RETURN MENU)

SET MARK 3

(RETURN MENU)

REPLACE WITH BLADE

(RETURN MENU)

Adjust the tip of the

alignment tool here.

Adjust the tip of the

alignment tool here.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 79 80

Commentaires sur ces manuels

Pas de commentaire

Roland CM-500 Spécifications Page 51

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel d'enregistrement Roland CM-500