Roland CM-500 Spécifications télécharger pdf (Page 29)

UNSETUP

CONDITION

3-5 Starting Cutting

Material Test Feed

Perform test feed beforehand to ensure that the roll material is not pulled with undue force during cutting.

If the roll material is pulled with undue force during cutting, a motor error may occur, or the position may be displaced. Test feed can

also be performed to make sure that the loaded material is straight.

Using the [AREA] feature makes it simple to perform test feed for the required portion.

Make sure that the type of the material has been selected using the operation panel and that material loading has been completed.

Make sure the brake is released.

Press the [MENU] key several times until the screen

shown in the figure appears.

Press the [ ] key.

Press the [

] key several times.

Press the [ ] key.

Use the [

] and [ ] keys to make the setting for the

required material length. Set the length that is about

0.2 m longer than the required material length.

(A positive value signifies material feed toward the

front, and a negative value signifies material feed

toward the back. If you are performing front loading,

set the length to a negative value. For more informa-

tion, see “4-6 Front Loading.” )

Press the [ENTER] key to perform test feed.

Press the [MENU] key to go back to the screen shown

in the figure.

AREA 1.0m

*2.0m

20cm/s

50gf 0.250mm A

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 79 80

Pas de commentaire

Roland CM-500 Spécifications Page 29