Roland CM-500 Spécifications télécharger pdf (Page 43)

4-6 Front Loading

You can use the front-loading feature of this machine, which lets you load roll material at the front of the machine, by installing the

sheet hangers on the front.

Installing the Sheet Hangers

Install the sheet hangers on the front of the machine.

For an explanation of how assemble the unit and the stand

(PNS-502/402/302), refer to the “ASSEMBLY INSTRUC-

TIONS” included with the stand.

Loading Material

Refer to “3-1 Loading the Material (Roll Material)”

and load the material.

At [SELECT SHEET], select either [ROLL] or [R-

EDGE]. Do not select [F-EDGE].

Follow the steps in “About the Origin Point and the

Cuttable Area” in the next section to set a new origin

point. In particular, not that if you have selected [R-

EDGE], cutting cannot be performed unless you set a

new origin point.

You cannot perform a cutting test immediately after you have selected [R-EDGE]. Use the [ ] key to feed the material

several centimeters (1 or 2 inches) toward the rear, then execute the cutting test. There is no particular need to set the

origin point.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 79 80

Pas de commentaire

Roland CM-500 Spécifications Page 43