Roland CM-500 Spécifications télécharger pdf (Page 24)

Material

Guide-line marks

Pinch roller (right)

Lower the pinch roller inside the

material.

Rear View

Sheet loading lever

Material

Pull out material toward the front, position it in place so that it is lined up straight with the guide lines, then move the left and

right pinch rollers to position them above the grit rollers.

Position the middle pinch roller at the center between the left and right pinch rollers. If a grit mark is present between the left

and right pinch rollers, position the middle pinch roller above the corresponding grit roller.

If the pinch rollers do not move smoothly, try moving them by grasping near the base of the sheet loading lever at the back of

the unit. Load the material so that it is straight. If the material is crooked, straight material feed cannot be performed.

* The GX-300 does not have a middle pinch roller.

Screws

Brake

Roll material

Stopper

Raise the sheet loading levers.

The pinch rollers are lowered and the material is

secured in place.

When using a material which is narrower than 762 mm

(30 in.), do not lower the middle pinch roller.

Position the stoppers so that they lightly touch the

edges of the roll and secure in place by tightening the

screws so that the roll material does not move from

side to side during material feed.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 79 80

Pas de commentaire

Roland CM-500 Spécifications Page 24