Roland CD-2u Manuel du propriétaire Page 126

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 140
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 125
126
Troubleshooting
(continued)
Problems with the Sound
Problem
Cause and Action
See
Page
No sound
Could the connections be incorrect?
Make the correct connections.
45, 50,
52
Could the power on the connected equipment (mic, digital piano, etc.)
be switched off?
Turn on the power.
Could the volume of the connected device be turned down?
Raise the volume of the connected device.
Could headphones be plugged in?
Unplug the headphones.
Is the volume set to the minimum?
Use the [VOLUME] knob to raise the volume.
70
Could the speakers be muted (turned off)?
Press the [Speaker] button so they’re turned on.
74
Could the [ ] (Record) button be blinking or lit?
In recording-standby mode or while recording, there will be no sound
from the speakers. Use headphones if you want to monitor the sound
during recording.
The input source (audio
source) is not output
Could the input level be turned down?
If you’ve connected external mics, turn the [MIC] knob to raise the input
level.
If you’re inputting audio via the LINE IN (L, R) jacks, turn the [LINE] knob
to raise the input level.
46
50, 52
Could MIC SELECT be set to “Internal
?
The sound from the internal mics won’t be heard from the speakers. Use
headphones if you want to monitor the sound of the internal mics.
41
Could MIC SELECT be set incorrectly?
If you want to record using the internal mics, set to “Internal.”
If you want to use external mics for your recording, set to the “External,”
“Ext(MONO),” or “Plug-In Power.”
41
45
The volume level of the
instrument connected to
EXT MIC (L, R), LINE IN is
too low.
Could you be using a connection cable that contains a resistor?
Use a connection cable that does not contain a resistor.
Could the external mic’s sensitivity be set to “Low”?
If the sound from the external mics is still not loud enough even after
you’ve adjusted the input level, set the “EXT MIC Sens” to “High.”
48
CD-2u_SD-2u_e.book 126 ページ 2013年1月24日 木曜日 午前11時34分
Vue de la page 125
1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 139 140

Commentaires sur ces manuels

Pas de commentaire