Roland CD-2u Manuel du propriétaire télécharger pdf (Page 32)

Preparing the Remote Control

(continued)

Point the remote control toward the CD-2u/SD-2u’s sensor, and operate it within the

specified operating range.

When the remote sensor detects a remote control operation, the [ENTER] button will

blink.

fig.remote02-e.eps

* Even if the remote control is within range, it may not work if there is an obstruction between it

and the remote sensor, or if the angle is excessive.

* The battery life will depend on the conditions of use. When the battery runs down, the operating

angle will become narrower. Replace the battery if this occurs.

* If you won’t be using the remote control for an extended period of time, remove the battery.

* If a spotlight or other strong light is directed at the remote sensor, it will be less responsive.

Using the Remote Control

If you want to prevent inadvertent operation of the remote control, you can disable

remote operation.

1 Press the [MENU] button to access the menu screen, and choose “Remote

Control.”

Press the [MENU] button to access the menu screen.

Use the [+] [-] buttons to choose “SYSTEM.”

Use the [ ] [ ] buttons to choose “Remote

Control.”

Press the [ENTER] button to confirm your choice.

2 Use the [+] [-] buttons to turn the remote control operation on/off.

fig.menu-remote02.eps

3 Press the [EXIT] button twice.

You’re returned to the audio source screen.

Disabling Remote Control Operation

Value Explanation

Off Remote operation will be disabled (off).

On (factory setting) Remote operation will be enabled (on).

CD-2u_SD-2u_e.book 32 ページ２０１３年１月２４日　木曜日　午前１１時３４分

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 139 140

Pas de commentaire

Roland CD-2u Manuel du propriétaire Page 32