Roland CD-2u Manuel du propriétaire Page 127
- Page / 140
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Troubleshooting
(continued)
127
Advanced UsesRecording Listening Deleting Creating a CD Editing an SD Appendices
Convenient
Functions
Information
/ Display
Checking /
Preparations
Problems with the Sound
(continued)
Problem
Cause and Action
See
Page
The sound recorded via
the internal mics is not
loud enough
●
Have you adjusted the input level of the internal mics?
➔
Turn the [MIC] knob to raise the input level of the internal mics.
42
The recorded sound is
noisy or distorted
●
Is the input level adjusted appropriately?
➔
Noise can tend to be become more noticeable if the sound being input
is at a relatively low level. On the other hand, distortion can crop up
when the level is high. Try to always keep the input level adjusted to a
setting that’s appropriately matched to the volume of the sound you’re
inputting.
➔
If you raise the input level when you’re using the external microphones
with limited sensitivity, any noise from the internal CD drive could
become more noticeable and might be recorded along with your
recording. If you feel dissatisfied with the outcome, try using the
following procedure when recording.
Use batteries to power the unit. (24)
Record to SD memory card. (45, 50, 52)
Use the AC adaptor to power the unit. (22)
Write the song data on the SD memory card to a CD. (95)
➔
Adjust the input level so that the PEAK indicator lights briefly when loud
sounds are input.
42, 46,
50, 52
●
Could the input level be raised for a jack to which no device is
connected?
➔
Even if no device is connected, we recommend that you turn down the
input level—turn the knob all the way to the left—for everything other
than the audio source you’re recording.
—
●
Could MIC SELECT be set to “Internal
”
?
➔
Even though you thought you were recording using the external mics,
a noisy recording may indicate that you were actually recording through
the internal mics. If you want to record using the external mics, set to
the “External,” “Ext(MONO),” or “Plug-In Power.”
45
●
Is the output level set correctly?
➔
If you raise the output level too high, noise or distortion may occur in
the sound from the internal speakers. Turn the [OUTPUT LEVEL] knob to
adjust the volume.
70
Unintended tone quality
●
Could you have made bass or treble settings?
➔
Set the bass and treble settings to “0.”
72
An unwanted effect is
applied to the sound
●
Could you have selected a reverb?
➔
Turn the reverb “Off.”
73
Volume changes are not
recorded correctly
according to the actual
performance
●
Could the [MIC LEVEL] switch be set to the “AUTO” position?
➔
The “AUTO” position is suitable for recording human voices at a
meeting or lecture, and may be unsuitable for recording an instrumental
performance. Change the setting to “MANUAL,” and turn the [MIC]
knob to adjust the input level.
44
CD-2u_SD-2u_e.book 127 ページ ２０１３年１月２４日 木曜日 午前１１時３４分
- Owner’s Manual 1
- Check the Included Items 3
- Table of Contents 4
- Deleting 5
- Creating a CD 5
- Advanced Uses 5
- Appendices 5
- List of Common Tasks 6
- USING THE UNIT SAFELY 8
- IMPORTANT NOTES 12
- Additional Precautions 13
- About the Licenses Agreement 13
- Panel Descriptions 14
- Remote Control 19
- 8x speed supported 20
- 4x/8x speeds supported 20
- Turning the Power On and Off 22
- About the Auto Off function 23
- Using Batteries 24
- Preparing an SD Memory Card 26
- Removing an SD Memory Card 28
- Preparing a CD 29
- Removing a CD 30
- Preparing the Remote Control 31
- Using the Remote Control 32
- Menu Operations 33
- List of Settings 34
- About Easy Guide 37
- Setting Items in Easy Guide 38
- 6. Overdub , 5. Overdub 40
- 7. Rehearsal , 6. Rehearsal 40
- (left channel) 41
- (right channel) 41
- If the input level is high 42
- If the input level is too low 42
- Blinking 43
- Remote control 43
- Switch setting Explanation 44
- Phone type, XLR type 45
- Types of plugs that can 45
- LouderQuieter 46
- PEAK indicator 46
- At this position 46
- Recording Karaoke 54
- Card Song and Recording It 59
- -48dB -6dB 62
- Track number Track number 64
- Adding Reverberation (Reverb) 73
- Sounding the Metronome 81
- Deleting Songs Individually 86
- Erasing All Tracks 87
- Song (Trim In) 88
- (Trim Out) 90
- Removing Finalization 94
- CD track number 95
- SD memory card track number 95
- Another CD Player (Finalize) 99
- (Backup) 100
- / Display 101
- (continued) 102
- Moving a Song 103
- Dividing a Track 104
- Joining Songs 106
- Remaining recording time 113
- (Spanish) 117
- (German) 117
- (French) 117
- (Italian) 117
- (Japanese) 117
- Condition (Factory Reset) 118
- Formatting an SD Memory Card 119
- Internal mic 122
- Connecting External Speakers 123
- OUT Jack 124
- Troubleshooting 125
- Problems with the Sound 126
- CD-Related Problems 128
- Messages 132
- Specifications 134
- For China 138
- For EU Countries 138
- Apparatus containing 139
- Lithium batteries 139
- Information 140
Produits connexes et manuels pour Matériel d'enregistrement Roland CD-2u
(16 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.562 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels