Roland GT-8 Manuel du propriétaire télécharger pdf (Page 75)

Chapter 7 Other Features

Chapter

Using the Digital Outs

Digital signals are output from the DIGITAL OUT connector

on the rear panel. You can connect this directly to the digital

in connector of a digital recorder or other device and record

with no degradation in sound quality.

fig.07-150

Adjusting the Output of DIGITAL OUT

You can adjust the level of the audio signals output from

DIGITAL OUT.

fig.07-152

Press [SYSTEM], then press PARAMETER [ ]

[ ] so that “SYS: Dgtl Out Lev” is displayed.

fig.07-153d

Rotate the PATCH/VALUE dial to adjust the output

level.

Valid Settings: 0%–200%

Press [EXIT] to return to the Play screen.

Checking the Effect Level

with the Level Meter

You can meter the output level of each effect. This is handy

for checking the effects’ output levels.

fig.07-131

Press [SYSTEM], then press PARAMETER [ ]

[ ] so that “METER” is displayed.

fig.07-140d

Rotate the PATCH/VALUE dial to select the effect

whose level you want to check.

* You can check the level of signals being input to the INPUT

jack by selecting “Input.” Selecting “Output” allows you to

check the level of signals output from the GT-8.

* You may not be able to achieve the effects you envision if your

output levels are set too high. Adjust the output level of each of

your effects to the optimum value while checking the meter

and making sure the needle doesn’t swing too far to the right.

Press [EXIT] to return to the Play screen.

DIGITAL IN

For more information on the following system settings,

refer to p. 54–p. 56.

SYS: CTL Pdl Func

SYS: EXP SW Func

SYS: EXP Pdl Func

SYS: SubCTL1 Func

SYS: SubCTL2 Func

SYS: Sub EXP Func

GT-8_e.book 75 ページ２００６年７月２５日　火曜日　午後１時４９分

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 107 108

Commentaires sur ces manuels

Pas de commentaire

Roland GT-8 Manuel du propriétaire Page 75

Commentaires sur ces manuels

Produits connexes et manuels pour Pianos numériques Roland GT-8