Roland GT-8 Manuel du propriétaire Page 37
- Page / 108
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
37
Chapter 4 Introduction to Effects and Parameters
Chapter
4
TR (Tremolo)
Tremolo is an effect that creates a cyclic change in volume.
PH (Phaser)
By adding varied-phase portions to the direct sound, the
phaser effect gives a whooshing, swirling character to the
sound.
Low
-50–+50
Adjusts the tone for the low frequency
range.
High
-50–+50
Adjusts the tone for the High frequency
range
Body
0–100
Adjusts the way the body sounds when
Type is set to ‘S’
→
Hollow, ‘H’
→
Hollow,
‘S‘
→
AC, ‘H’
→
AC, or ‘P’
→
AC.
The body sound increases as the value is raised; reducing the value
produces a tone similar to that from a piezo pickup.
Level
0–100
Adjusts the volume.
Parameter/
Range
Explanation
Wave Shape
0–100
Adjusts changes in volume level.
Rate
0–100,
BPM –BPM
Adjusts the frequency (speed) of the change.
* When set to BPM, the value of each parameter will be set according to
the value of the Master BPM (p. 51) specified for each patch. This makes
it easier to achieve effect sound settings that match the tempo of the
song (synchronizing the cycle to one-half or one-fourth of the BPM
when the set cycle rate is increased).
When setting to BPM, press PARAMETER [ ] several times to
display the Master BPM settings screen.
Depth
0–100
Adjusts the depth of the effect.
Parameter/
Range
Explanation
Parameter/
Range
Explanation
Type
see below
Selects the number of stages that the phaser
effect will use.
4 Stage
This is a four-phase effect. A light phaser ef-
fect is obtained.
8 Stage
This is an eight-phase effect. It is a popular
phaser effect.
12 Stage
This is a twelve-phase effect. A deep phase
effect is obtained.
Bi-Phase
This is the phaser with two phase shift cir-
cuits connected in series.
Rate
0–100,
BPM –BPM
This sets the rate of the phaser effect.
* When set to BPM, the value of each parameter will be set according to
the value of the Master BPM (p. 51) specified for each patch. This makes
it easier to achieve effect sound settings that match the tempo of the
song (synchronizing the cycle to one-half or one-fourth of the BPM
when the set cycle rate is increased).
When setting to BPM, press PARAMETER [ ] several times to
display the Master BPM settings screen.
Depth
0–100
Determines the depth of the phaser effect.
Manual
0–100
Adjusts the center frequency of the phaser
effect.
Resonance
0–100
Determines the amount of resonance (feed-
back).
Increasing the value will emphasize the effect, creating a more un-
usual sound.
Step Rate
Off, 0–100,
BPM –BPM
This sets the cycle of the step function that
changes the rate and depth.
When it is set to a higher value, the change will be finer. Set this to
“Off” when not using the Step function.
* When set to BPM, the value of each parameter will be set according to
the value of the Master BPM (p. 51) specified for each patch. This makes
it easier to achieve effect sound settings that match the tempo of the
song (synchronizing the cycle to one-half or one-fourth of the BPM
when the set cycle rate is increased).
When setting to BPM, press PARAMETER [ ] several times to
display the Master BPM settings screen.
Effect Level
0–100
Adjusts the volume of the phaser.
Direct Level
0–100
Adjusts the volume of the direct sound.
GT-8_e.book 37 ページ ２００６年７月２５日 火曜日 午後１時４９分
- Owner’s Manual 1
- IMPORTANT NOTES 4
- Contents 5
- Main Features 8
- Front Panel 9
- Rear Panel 12
- Chapter 1 Playing Sounds 13
- Device (Amp) (Output Select) 14
- Turning Off the Power 15
- Switching Only the Number 16
- Switching the Bank and Number 17
- Turning the Effect On and Off 18
- Naming Patches (Patch Name) 21
- Copying Patches (Patch Copy) 22
- Destination User Patch 23
- Storing Settings by Effect 24
- (User Quick Settings) 24
- Copying the PREAMP/SPEAKER 25
- Settings to Another Channel 25
- PREAMP/SPEAKER (Preamp/ 26
- Speaker Simulator) 26
- Type List 28
- OVERDRIVE/DISTORTION 29
- OUTPUT L 30
- OUTPUT R 30
- Using the HOLD (Hold Delay) 31
- COMP (Compressor) 33
- FX-1/FX-2 34
- TR (Tremolo) 37
- PH (Phaser) 37
- STR (Sitar Simulator) 40
- FB (Feedbacker) 40
- WSY (Wave Synth) 42
- SEQ (Sub Equalizer) 42
- HR (Harmonist) 43
- PS (Pitch Shifter) 44
- 2CE (2 x 2 Chorus) 46
- AR (Auto Riff) 46
- AC (Acoustic Processor) 48
- EQ (Equalizer) 49
- LOOP (External Effects Loop) 50
- AMP CTL (Amp Control) 50
- When the pedal 51
- Use-Specific Guide 53
- Setting the Operation of the 54
- Quick Settings 57
- Manual Settings 58
- When using the foot switch: 59
- When using the EXP pedal: 59
- EXP pedal: 60
- Setting Assign Input Sens 60
- Internal Pedal System 61
- Wave Pedal 62
- Chapter 6 63
- Customizing the Speakers 64
- Customizing 65
- Overdrive/Distortion 65
- Customizing Pedal Wah 66
- Chapter 7 Other Features 67
- (Example) 68
- Input Level 70
- Input Pres. (Input Presence) 70
- Setting the System Preamp 71
- Limiting the Banks That Can 72
- Be Switched (Bank Extent) 72
- Selecting the PATCH/VALUE 73
- Dial Function (Dial Function) 73
- DIGITAL IN 75
- Tuning the Guitar 76
- On and Off With the Pedals 78
- Chapter 8 79
- Making the Settings for MIDI 80
- Functions 80
- Transmitting and Receiving 81
- MIDI Data 81
- MIDI Device (Bulk Load) 82
- Error Messages 88
- Troubleshooting 89
- Restoring the Factory 90
- Settings (Factory Reset) 90
- Adjusting the EXP Pedal 91
- MIDI Implementation Chart 92
- Specifications 93
- Preset Patch 99
- Patch List 100
- Appendices 101
- Apparatus containing 107
- Lithium batteries 107
Produits connexes et manuels pour Pianos numériques Roland GT-8
(2 pages)
(64 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.249 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels