Roland GT-8 Manuel du propriétaire Page 40
- Page / 108
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
40
Chapter 4 Introduction to Effects and Parameters
STR (Sitar Simulator)
This simulates the sound of the sitar.
FB (Feedbacker)
This allows you to use feedback playing techniques.
* Note that the notes you want to apply feedback to must be
played singly and cleanly.
* You can use the foot switch to switch the effect on and off. For
more details, refer to p. 57.
*1
Setting available with Mode set to OSC.
Parameter/
Range
Explanation
Tone
-50–+50
This adjusts the tone.
The high end is boosted as the value increases.
Sens
0–100
Adjusts the sensitivity of the sitar.
When it is set to a lower value, no effect of the sitar is obtained with
weaker picking, while stronger picking produces the effect. When it
is set to a higher value, the effect of the sitar can be obtained whether
the picking is weak or strong.
Depth
0–100
This adjusts the amount of effect applied.
Resonance
0–100
This adjusts the undulation of the reso-
nance.
Buzz
0–100
Adjusts the amount of characteristic buzz
produced by the “buzz bridge” when the
strings make contact with it.
Effect Level
0–100
Adjust the volume of the sitar sound.
Direct Level
0–100
Adjust the volume of the direct sound.
Parameter/
Range
Explanation
Mode
OSC, Natural
Select either oscillator “OSC” or natural
“Natural.”
OSC (Oscillator)
An artificial feedback sound will be created internally.
When OSC is selected, the effect is activated after a single note is
played and the note stabilizes. A feedback effect is created when the
effect switches on; the feedback disappears when the OSC effect
switches off.
Natural
Analyzes the pitch of the guitar sound being input, and then creates
a feedback sound.
Rise Time *1
0–100
This determines the time needed for the vol-
ume of the feedback sound to reach its max-
imum from the moment the effect is turned
on.
Rise Time (
▲
) *1
0–100
This determines the time needed for the vol-
ume of the one octave higher feedback
sound to reach its maximum from the mo-
ment the effect is turned on.
F.B.Level (Feedback Level)
0–100 Adjusts the volume of the feedback sound.
F.B.Level (
▲
) *1
0–100
Adjusts the volume of the one octave higher
feedback sound.
Vibrato Rate *1
0–100,
BPM –BPM
Adjusts the rate of the vibrato when the
feedbacker is on.
* When set to BPM, the value of each parameter will be set according to
the value of the Master BPM (p. 51) specified for each patch. This makes
it easier to achieve effect sound settings that match the tempo of the
song (synchronizing the cycle to one-half or one-fourth of the BPM
when the set cycle rate is increased).
When setting to BPM, press PARAMETER [ ] several times to
display the Master BPM settings screen.
Vibrato Depth *1
0–100
Adjusts the depth of the vibrato when the
feedbacker is on.
GT-8_e.book 40 ページ ２００６年７月２５日 火曜日 午後１時４９分
- Owner’s Manual 1
- IMPORTANT NOTES 4
- Contents 5
- Main Features 8
- Front Panel 9
- Rear Panel 12
- Chapter 1 Playing Sounds 13
- Device (Amp) (Output Select) 14
- Turning Off the Power 15
- Switching Only the Number 16
- Switching the Bank and Number 17
- Turning the Effect On and Off 18
- Naming Patches (Patch Name) 21
- Copying Patches (Patch Copy) 22
- Destination User Patch 23
- Storing Settings by Effect 24
- (User Quick Settings) 24
- Copying the PREAMP/SPEAKER 25
- Settings to Another Channel 25
- PREAMP/SPEAKER (Preamp/ 26
- Speaker Simulator) 26
- Type List 28
- OVERDRIVE/DISTORTION 29
- OUTPUT L 30
- OUTPUT R 30
- Using the HOLD (Hold Delay) 31
- COMP (Compressor) 33
- FX-1/FX-2 34
- TR (Tremolo) 37
- PH (Phaser) 37
- STR (Sitar Simulator) 40
- FB (Feedbacker) 40
- WSY (Wave Synth) 42
- SEQ (Sub Equalizer) 42
- HR (Harmonist) 43
- PS (Pitch Shifter) 44
- 2CE (2 x 2 Chorus) 46
- AR (Auto Riff) 46
- AC (Acoustic Processor) 48
- EQ (Equalizer) 49
- LOOP (External Effects Loop) 50
- AMP CTL (Amp Control) 50
- When the pedal 51
- Use-Specific Guide 53
- Setting the Operation of the 54
- Quick Settings 57
- Manual Settings 58
- When using the foot switch: 59
- When using the EXP pedal: 59
- EXP pedal: 60
- Setting Assign Input Sens 60
- Internal Pedal System 61
- Wave Pedal 62
- Chapter 6 63
- Customizing the Speakers 64
- Customizing 65
- Overdrive/Distortion 65
- Customizing Pedal Wah 66
- Chapter 7 Other Features 67
- (Example) 68
- Input Level 70
- Input Pres. (Input Presence) 70
- Setting the System Preamp 71
- Limiting the Banks That Can 72
- Be Switched (Bank Extent) 72
- Selecting the PATCH/VALUE 73
- Dial Function (Dial Function) 73
- DIGITAL IN 75
- Tuning the Guitar 76
- On and Off With the Pedals 78
- Chapter 8 79
- Making the Settings for MIDI 80
- Functions 80
- Transmitting and Receiving 81
- MIDI Data 81
- MIDI Device (Bulk Load) 82
- Error Messages 88
- Troubleshooting 89
- Restoring the Factory 90
- Settings (Factory Reset) 90
- Adjusting the EXP Pedal 91
- MIDI Implementation Chart 92
- Specifications 93
- Preset Patch 99
- Patch List 100
- Appendices 101
- Apparatus containing 107
- Lithium batteries 107
Produits connexes et manuels pour Pianos numériques Roland GT-8
(2 pages)
(64 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.153 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels