Roland VG-88 Manuel du propriétaire Page 53
- Page / 84
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
53
EFFECTS Chapter 5. Parameter Guide
Chapter 5
This effect adds delayed sound to the direct sound, giving
more body to the sound or creating special effects.
ON/OFF
Switches the DELAY on/off.
* Turning [VALUE] will select PRESET.
DLY TIME (delay time)
[0–1800 msec, BPM –BPM ]
This determines the delay time.
* When set to BPM, the value of each parameter will be set
according to the value of the BPM (p. 55) specified for each
patch. This makes it easier to achieve effect sound settings that
match the tempo of the song (synchronizing the time to twice
or four times the time length of the BPM when the set time is
increased).
* To adjust the setting in 1 msec units, press [F4] (FINE).
TAP TIME [OFF, 0–100%]
Adjusts the delay time of the right channel delay. This setting
adjusts the right channel delay time relative to the left
channel delay time (considered as 100%).
FEEDBACK [0–100]
“Feedback” is returning a delay signal to the input. This
parameter determines the amount of feedback. A higher
value will increase the number of the delay repeats.
HIGH CUT (high-cut filter)
[700 Hz–11.0 kHz, FLAT]
The high-cut filter cuts the frequency contents that are higher
than the set frequency. This parameter adjusts the frequency
where the high-cut filter starts working. When it is set to
“Flat,” the high-cut filter does not work at all.
DLY LEV (delay level) [0–120]
Adjusts the volume of the delay sound.
In this effect, a slightly detuned sound is added to the
original sound to add depth and breadth.
ON/OFF
Switches the CHORUS on/off.
* Turning [VALUE] will select PRESET.
MODE
Selection for the chorus mode.
MONO:
This chorus effect outputs the same sound from both L
and R.
STEREO:
This is a stereo chorus effect that adds different chorus
sounds to L and R.
RATE [0–100, BPM –BPM ]
Adjusts the rate of the chorus effect.
* When set to BPM, the value of each parameter will be set
according to the value of the BPM (p. 55) specified for each
patch. This makes it easier to achieve effect sound settings that
match the tempo of the song.
DEPTH [0–100]
Adjusts the depth of the chorus effect. To use it for doubling,
set the value to “0.”
PRE DLY (pre delay)
[0.0–40.0 msec] (0.5 msec steps)
Adjusts the time needed for the effect sound to be output
after the direct sound has been output. By setting a longer
pre delay time, you can obtain an effect that sounds like
more than one sound is being played at the same time
(doubling effect).
HIGH CUT (high-cut filter)
[700 Hz–11.0 kHz, FLAT]
The low-cut filter cuts the frequencies below the specified
frequency. This setting adjusts the frequency at which the
low-cut filter will begin to take effect. When “FLAT” is
selected, the low-cut filter will have no effect.
CE LEVEL (chorus level) [0–100]
Adjusts the volume of the chorus sound.
DELAY CHORUS
- Owner’s Manual 1
- IMPORTANT SAFETY INSTRUCTIONS 2
- SAVE THESE INSTRUCTIONS 2
- USING THE UNIT SAFELY 3
- Contents 5
- Birth of the V-Guitar System 8
- ■ Sound Modeling 8
- ■ Composite Object Sound 8
- Modeling: COSM 8
- Main features 9
- How to use this manual 10
- IMPORTANT NOTES 11
- Front and Rear Panels 12
- Rear Panel 13
- Connecting an amp etc 14
- Chapter 1 15
- ■ Tuning your guitar 17
- Specify the driver settings 18
- ■ Name the GK pickup settings 21
- Changing sounds (patches) 22
- ■ Using the VALUE dial to 23
- ■ Using pedals to change 23
- =+ + . . .++ 24
- Chapter 3 25
- COSM GUITAR settings 27
- COSM AMP settings 28
- EFFECTS settings 28
- Chapter 4 29
- 88’s built-in CTL pedal 30
- ■ Setting the GK VOL function 30
- ■ Setting the GK SW function 31
- ACTIVE RANGE HI: 127 32
- Mixer point 33
- Assigning a name to the patch 34
- Chapter 5. Parameter Guide 36
- Chapter 5 37
- COSM GUITAR 38
- PT SHIFT (pitch shift) BODY 39
- PD SHIFT (pedal pitch shift) 41
- POLY DISTORTION 41
- (polyphonic distortion) 41
- POLY COMP/LIMITER 42
- PWM MOD (PWM modulation) 44
- BODY LEV (body level) 44
- EQ (equalizer) PAN 45
- COSM AMP 46
- COMP/LM (COMPRESSOR/LIMITER) 47
- EQ (equalizer) 48
- MOD (modulation) 49
- DELAY CHORUS 53
- REVERB NS (noise suppressor) 54
- FV (foot volume) 54
- LEVEL/BPM/KEY 55
- PEDAL/ASSIGN 55
- CONTRAST 56
- GK FUNC (GK function) 57
- OUTPUT SELECT 58
- EXCHANGE 61
- GK pickup settings 62
- Pedal function settings 64
- VALUE dial settings 66
- GK pickup function settings 66
- Chapter 6 67
- Chapter 7. Using MIDI 68
- Chapter 7 69
- ■ About MIDI Omni Mode 69
- ■ About the MIDI Device ID 69
- ■ Bank Select and Program 69
- ■ Setting the Program Change 71
- ■ Synchronizing to the MIDI 71
- CLOCK arriving at MIDI IN 71
- ■ Receiving settings from an 72
- Chapter 8. Appendices 73
- (Initialization) 74
- MIDI Implementation Chart 75
- Specifications 76
- VG-88 PATCH LIST 79
- PEDAL/ASSIGN Parameter List 81
Produits connexes et manuels pour Instruments de musique Roland VG-88
(2 pages)
(60 pages)
(2 pages)© 2020, manymanuals.fr. Tous droits réservés | 2.272 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels