Roland VG-88 Manuel du propriétaire télécharger pdf (Page 18)

Chapter 1. Preparations for playing

Play a single unfretted note on the string you wish to

tune.

The note name closest to the string you played will

appear in the LED display.

* Cleanly play a single note only on the string that you wish to tune.

fig.1-06

4. Adjust the tuning until the note name of the string you

played appears in the display.

5. While watching the display, adjust the tuning until only

the middle indicator (tuned) is lit.

6. Repeat steps 3 – 5 to tune all the strings.

* When tuning a guitar that has a tremolo arm, tuning one

string may cause the other strings to go out of tune. In such

cases, first tune the strings to the approximate pitch (so that

the note name is displayed), and then keep tuning each string

until they are all in tune.

When you have finished tuning, press [TUNER] or

[EXIT].

Specify the driver settings

The sound quality of the VG-88 is dramatically affected by

how the divided pickup is installed. To ensure that the VG-

88 always plays with the best possible sound quality, you

must adjust the pickup driver settings. These settings

provide the VG-88 with information that allows it to

compensate for, and minimize, any unevenness in sound due

to the nature of the divided pickup’s installation.

If you have two or more guitars that you wish to use with the

VG-88, you must enter driver settings for the divided pickup

of each guitar. For each guitar, use the following procedure.

Settings for up to five guitars can be made and stored.

When playing the VG-88, driver settings are extremely

important to the final sound quality. You must be sure to set

these parameters correctly.

fig.1-08

1. Press [F6] (SYSTEM). The System screen will appear.

fig.1-14

2. Press [F1] (DRIVER). The driver setting screen will

appear.

fig.1-10

3. Specify the driver settings.

Move the cursor to “SETTING.” Use [VALUE] to select

the driver settings for your guitar. There are five setting

memories (A–E), allowing you to save five setups

comprised of the values you select in the following Steps

4–7.

You can simply select the appropriate driver setting

whenever you switch guitars so that the optimal settings for

that guitar are immediately available.

4. Select the driver type.

Move the cursor to “TYPE.” Use [VALUE] to select the

type of divided pickup that is installed on your guitar.

D D

E F

3,4,5,6,7,8

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 83 84

Commentaires sur ces manuels

Pas de commentaire

Roland VG-88 Manuel du propriétaire Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de musique Roland VG-88