Roland VG-88 Manuel du propriétaire Page 38

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 84
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 37
38
Chapter 5. Parameter Guide COSM GUITAR
VARI (variable):
This allows you to use up to two pickups of your choice,
selecting from double-coil, single-coil, piezo, and
acoustic. If you use double-coil or single-coil type
pickups, you may freely adjust the location of the
pickups.
PICKUP
This is the switch that selects between the two pickups.
REAR: Use the rear pickup.
C+R: Use both center and rear pickups.
CENTER: Use the center pickup.
F+C: Use both front and center pickups.
FRONT: Use the front pickup.
F+R: Use both front and rear pickups.
TONE [-50–+50]
Adjusts the tone of the pickup. Positive (+) values will boost
the high range, and negative (-) values will attenuate it.
LEVEL [0–100]
Sets the volume of the pickup. With a setting of 0, there will
be no sound.
TYPE
Selects the type of pickup.
SINGLE:
Single-coil pickup.
DOUBLE:
Double-coil pickup.
ACOUSTIC:
A hypothetical pickup ideal for picking up the sound of
an acoustic guitar.
PIEZO:
Piezo pickup.
MIC:
A hypothetical mic ideal for picking up the sound of an
acoustic guitar.
* If you have COSM GUITAR TYPE set to “ACOUSTIC,” the
“SINGLE,” “DOUBLE,” and “ACOUSTIC” settings then
become unavailable.
* This cannot be set to “MIC” if anything other than
“ACOUSTIC” is selected for the COSM GUITAR TYPE
setting.
PHASE
When pickups FRONT and REAR are mixed, this setting
determines the phase of pickup REAR relative to pickup
FRONT.
IN:
It will have the same phase as pickup FRONT.
OUT:
It will be mixed in opposite phase. This is valid only
when two pickups are being used.
* The phase setting that is part of the pickup FRONT
parameters is the same as the corresponding parameter for
pickup REAR. Modifying one of them will cause the other
parameter to change correspondingly.
POSITION [5–320 mm]
Specifies the distance from the bridge at which the pickup is
placed. Larger values will produce the effect of the pickup
being further from the bridge.
* If the Pickup Type has been set to “PIEZO” or “ACOUSTIC”
the POSITION setting will not be available.
ANGLE [-315–+315 mm]
This simulates the angle of the pickup relative to the strings.
The setting indicates the distance from the POSITION setting
that the sixth string will be located. With positive (+) settings,
the sixth string will be further from the bridge. With negative
(-) values, the sixth string will be closer to the bridge. With a
setting of 0, the pickup will be perpendicular with the
strings.
fig.5-01
* If “PIEZO” or “ACOUSTIC” is selected as the pickup type,
the Angle setting will not be available.
* Angle settings which would exceed the range of the Position
setting (5–320 mm) will have no effect. For example, if the
Position is set to 100 mm, and valid range of the Angle setting
will be -95–+220 mm.
POSITION ANGLE
BRIDGE
1
2
3
4
5
6
Vue de la page 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 83 84

Commentaires sur ces manuels

Pas de commentaire