
23
● 0130: Compressor
Flattens out high levels and boosts low levels, smoothing out fluctuations in
volume.
No Parameter Value Description
1 Attack #2 0-127 0-127
Sets the speed at which
compression starts
2 Threshold #1 0-127 0-127
Adjusts the volume at which
compression begins
3 Post Gain 0-18 0 - +18 dB Adjusts the output gain.
4 Low Gain 0-30 -15 - +15 dB Gain of the low frequency range
5 High Gain 0-30 -15 - +15 dB Gain of the high frequency range
6 Level 0-127 0-127 Output level
● 0131: Limiter
Compresses signals that exceed a specified volume level, preventing distortion
from occurring.
No Parameter Value Description
1 Release 0-127 0-127
Adjusts the time after the signal
volume falls below the Threshold
Level until compression is no
longer applied.
2 Threshold #1 0-127 0-127
Adjusts the volume at which
compression begins
3 Ratio #2 0-3
1.5:1, 2:1, 4:1,
100:1
Compression ratio
4 Post Gain 0-18 0 - +18 dB Adjusts the output gain.
5 Low Gain 0-30 -15 - +15 dB Gain of the low frequency range
6 High Gain 0-30 -15 - +15 dB Gain of the high frequency range
7 Level 0-127 0-127 Output level
● 0142: Stereo Chorus
This is a stereo chorus. A filter is provided so that you can adjust the timbre of
the chorus sound.
No Parameter Value Description
1 Filter Type 0-2 Off, Lpf, Hpf
Type of filter
Off: No filter is used
Lpf: Cuts the frequency range
above the Cutoff Freq
Hpf: Cuts the frequency range
below the Cutoff Freq
2 Cutoff Freq 0-16 200-8000 Hz Basic frequency of the filter
3 Pre Delay 0-125 0.0-100.0 ms
Adjusts the delay time from the
direct sound until the chorus
sound is heard.
4 Rate Mode 0-1 Hz, note
When this is set to “note,” the
effect is synchronized with the
tempo.
5 Rate #1 1-127 0.05-10.00 Hz Frequency of modulation (Hz)
6 Rate 0-21 note Frequency of modulation (note)
7 Depth #2 0-127 0-127 Depth of modulation
8 Phase 0-90 0-180 deg Spatial spread of the sound
9 Low Gain 0-30 -15 - +15 dB Gain of the low range
10 High Gain 0-30 -15 - +15 dB Gain of the high range
11 Balance 0-100
D100:0W -
D0:100W
Volume balance between the direct
sound (D) and the chorus sound
(W)
12 Level 0-127 0-127 Output Level
● 0140: Hexa Chorus
Uses a six-phase chorus (six layers of chorused sound) to give richness and
spatial spread to the sound.
No Parameter Value Description
1 Pre Delay 0-125 0.0-100.0 ms
Adjusts the delay time from the
direct sound until the chorus
sound is heard.
2 Rate Mode 0-1 Hz, note
When this is set to “note,” the
effect is synchronized with the
tempo.
3 Rate #1 1-127 0.05-10.00 Hz Frequency of modulation (Hz)
4 Rate 0-21 note Frequency of modulation (note)
5 Depth #2 0-127 0-127 Depth of modulation
6 Pre Delay Deviation 0-20 0-20
Adjusts the differences in Pre
Delay between each chorus
sound.
7 Depth Deviation 0-40 -20 - +20
Adjusts the difference in
modulation depth between each
chorus sound.
8 Pan Deviation 0-20 0-20
Adjusts the difference in stereo
location between each chorus
sound. 0: All chorus sounds will be
in the center. 20: Each chorus
sound will be spaced at 60 degree
intervals relative to the center.
9 Balance 0-100
D100:0W -
D0:100W
Volume balance between the direct
sound (D) and the chorus sound
(W)
10 Level 0-127 0-127 Output Level
● 0141: Tremolo Chorus
This is a chorus effect with added Tremolo (cyclic modulation of volume).
No Parameter Value Description
1 Pre Delay 0-125 0.0-100.0 ms
Adjusts the delay time from the
direct sound until the chorus
sound is heard.
2 Chorus Rate Mode 0-1 Hz, note
When this is set to “note,” the
effect is synchronized with the
tempo.
3 Chorus Rate 1-127 0.05-10.00 Hz
Modulation frequency of the
chorus effect (Hz)
4 Chorus Rate 0-21 note
Modulation frequency of the
chorus effect (note)
5 Chorus Depth #1 0-127 0-127
Modulation depth of the chorus
effect
6 Tremolo Rate Mode 0-1 Hz, note
When this is set to “note,” the
effect is synchronized with the
tempo.
7 Tremolo Rate #2 1-127 0.05-10.00 Hz
Modulation frequency of the
tremolo effect (Hz)
8 Tremolo Rate 0-21 note
Modulation frequency of the
tremolo effect (note)
9 Tremolo Separation 0-127 0-127 Spread of the tremolo effect
10 Tremolo Phase 0-90 0-180 deg Spread of the tremolo effect
11 Balance 0-100
D100:0W -
D0:100W
Volume balance between the direct
sound (D) and the tremolo chorus
sound (W)
12 Level 0-127 0-127 Output Level
Commentaires sur ces manuels