Roland SPD-S Manuel d'utilisateur télécharger pdf (Page 19)

Setup Guide

Mounting on a Stand

To mount the SPD-S on a cymbal stand or other type of stand, use a separately sold APC-33 all-purpose clamp set to attach the

stand holder. It can be attached to a pipe with a diameter of 10.5 to 30 mm.

Using a 4 mm wrench included with the all-purpose clamp (APC-33), remove the four screws from the SPD-S's bottom panel.

Use these removed screws to attach the stand holder of the APC-33 to the bottom panel of the SPD-S.

Do not use the screws included with the APC-33.

When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the four corners or at both

ends to prevent damage to the buttons and controls. Also, you should try to orient the unit so no buttons or controls get damaged.

When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.

Make sure that the stand is installed in an appropriate place to ensure stability.

Do not mount the SPD-S on any stand that is insufficiently robust.

SPDS_e.book 19 ページ２００４年４月１９日　月曜日　午前９時５８分

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 143 144

Pas de commentaire

Roland SPD-S Manuel d'utilisateur Page 19