Roland RT-10T Manuel d'utilisateur télécharger pdf (Page 8)

Mounting The Drum Trigger

Set the sensor bolt so that the sensor compresses approximately 2–3 mm when pressed against the head.

* The position of the secured sensor and the amount of this compression play an important role in the

performance of the trigger.

* Make sure that the sensor constantly remains in contact with the head, even when playing the drum.

* This setting is very important. If the sensor is compressed too much against the head, it could cause re-

triggering when the head is played. (meaning more than one sound when you hit the head only once)

Use a stereo cable (included) to connect the drum trigger and the percussion sound module.

Make sure the cable does not touch the trigger (other than the connection) or the drum itself.

* When using the RT-10S Snare Trigger, rim shots cannot be played if a monaural cable is used.

* More details regarding percussion sound modules capable of processing RT-10S Snare Trigger rim shots

can be found here. “Percussion Sound Module Parameter Settings” (p. 14).

921

* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn

off the power on all devices before making any connections.

Adjusting the Sensor Position (Sensor Bolt)

Connecting a Percussion Sound Module

RT-10S/RT-10T

RT-10K

Remove

your fingers

Press

Head

Press

Remove

your fingers

RT-10KST_e.fm 8 ページ２００６年３月３０日　木曜日　午後１時５５分

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Pas de commentaire

Roland RT-10T Manuel d'utilisateur Page 8