Roland Metaza MPX-80 Manuel d'utilisateur télécharger pdf (Page 30)

Chapter 3 Performing Printing

3-3 Getting Ready to Print

Preparing Material to Print

Prepare material that meets all of the following conditions.

Loading material that is larger or thinner than this may cause the material to warp during printing and strike the head,

damaging the marking pin.

Thickness

When using the

adhesive sheet:

When using the

center vise:

Size

When using the

adhesive sheet:

When using the

center vise:

0.3 to 40 mm (0.012 to 1.5 in.)

0.3 to 20 mm (0.012 to 0.7 in.)

Length (or width) of 90 mm (3.5 in.) or less

Width of 60 mm (2.3 in.) or less (subject to change depending on the orientation of the

installed vise) Length of 100 (3.9 in.) mm or less

☞ P. 33, "Using the Center Vise"

* Note that even if thickness and size are within the range as described above, it may not be

possible to perform printing correctly on materials that warp when struck. Refer to the table

below, which provides a general guide to printable sizes according to thicknesses.

Hardness of surface

to print

Vickers hardness (HV) of 200 or less

* Note that materials which may crack or split by printing (such as glass, stone, precious

stones, china, and porcelain) cannot be printed even if hardness is within the preceding range.

Attempting to print such materials may damage the machine.

Thickness

2.0 mm (0.08 in.)

1.5 mm (0.06 in.)

1.0 mm (0.04 in.)

0.5 mm (0.02 in.)

0.3 mm (0.01 in.)

2.0 mm (0.08 in.)

1.5 mm (0.06 in.)

1.0 mm (0.04 in.)

0.5 mm (0.02 in.)

0.3 mm (0.01 in.)

2.0 mm (0.08 in.)

1.0 mm (0.04 in.)

Material

Aluminium

Brass or copper

Stainless steel

Printable material size (general guide)

Length (or width) of 60 mm (2.3 in.) or less

Length (or width) of 40 mm (1.5 in.) or less

Length (or width) of 30 mm (1.1 in.) or less

Length (or width) of 20 mm (0.7 in.) or less

Length (or width) of 60 mm (2.3 in.) or less

Length (or width) of 40 mm (1.5 in.) or less

Length (or width) of 30 mm (1.1 in.) or less

Length (or width) of 15 mm (0.5 in.) or less

Length (or width) of 60 mm (2.3 in.) or less

Length (or width) of 40 mm (1.5 in.) or less

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 95 96

Commentaires sur ces manuels

Pas de commentaire

Roland Metaza MPX-80 Manuel d'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Roland Metaza MPX-80