Roland Metaza MPX-80 Manuel d'utilisateur télécharger pdf (Page 37)

Chapter 3 Performing Printing

3-5 Loading Material (Using the Center Vise)

➍

Mount the center vise.

Fit the tabs on the bottom of the center vise

into the holes in the table on the unit.

(Remove the adhesive sheet first.)

If you’re performing printing with the head cap attached, this completes loading of the material.

If you’re performing printing with no head cap attached, then go on to the following steps.

The procedure from this point on is for when you’re not using the head cap.

➎

Press the Power/Movement button.

The table and head move, and stop at the lo-

cation where the tip of the nose cap touches

the surface of the material.

➏

Lock the knob to set the head height.

Gently lift the knob, then secure it in place at

a position flush against the head unit.

➐

Press the Power/Movement button.

Wait for the movement of the head

to stop, then detach the head cap.

Knob

Head unit

Head cap

Roland

Center vice

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 95 96

Pas de commentaire

Roland Metaza MPX-80 Manuel d'utilisateur Page 37