Roland Metaza MPX-80 Manuel d'utilisateur télécharger pdf (Page 29)

Chapter 3 Performing Printing

3-3 Getting Ready to Print

The Printable Area

The machine's printable area is as follows.

Head Caps

Using the head cap is usually recommended.

When you’re using a head cap, the machine can detect the height position of the material, so setting the head height

during printing is not necessary. Also, the head tracks the surface height of the material, so even cylindrical material

can be printed. (Trackable height displacement is subject to an upper limit.) This means that it’s usually a good idea to

carry out printing using a head cap.

☞ P. 29, "Conditions for Material When Printing Curved Surfaces," p. 69, "The Replacement Cycle for the Head Cap"

If the material is damaged when using the head cap.

Some materials may be damaged by the head cap, and so the head cap cannot be used when printing such materials.

In such cases, determine the head height while the head cap is attached and secure the head in place, then remove the

head cap and carry out printing.

☞ P. 31, "Loading Material (Using the Adhesive Sheet)," p. 33, "Loading Material (Using the Center Vise)"

Center

line

Center

line

Printable area

(50 x 50 mm (1.9 x 1.9 in.))

Top view of the table

Expanded printing area

(80 x 80 mm (3.1 x 3.1 in.))

Note : Depending on the mate-

rial and the image, the printing

results in the expanded area may

be uneven.

Head cap

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 95 96

Pas de commentaire

Roland Metaza MPX-80 Manuel d'utilisateur Page 29