Roland AXIS-1 Manuel d'utilisateur télécharger pdf (Page 60)

Chapter 5 Getting Ready for and Performing Cutting

5-2 Starting Cutting

Overview of the Procedure

This is an overview of the procedures to follow before you start cutting. This section describes a common cutting method

that involves aligning the Y- and Z-axis origins with the center of the A axis.

Set the Y-axis Origin

Perform detection of the A-axis center, then set the Y-axis origin.

 P. 43, "4-2 Setting the Y-axis Origin" v

Load the Workpiece and Install the Tool

Before you do this, familiarize yourself with such basic knowledge as how to use the workpiece chuck and the limitations

on workpieces and tools.

 P. 31, "Chapter 3 - Basic Operation"

 P. 56, "5-1 Cutting Area"

Set the Z-axis Origin

Before you set the Z-axis origin, rst install the tool.

 P. 48, "4-3 Setting the Z-axis Origin"

Set the Cutting-start Location

Set the X- and A-axis origins to match the workpiece.

 P. 59, "Setting the Cutting-start Location"

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 79 80

Pas de commentaire

Roland AXIS-1 Manuel d'utilisateur Page 60