Roland AXIS-1 Manuel d'utilisateur télécharger pdf (Page 30)

2-2 Step 1: Install the Unit

Chapter 2 Installation

For a T-slot Table

The installation method diers depending on the type of table attached. If you're using a modeling machine equipped with

a T-slot table, then use this method to install.

Procedure



Prepare the modeling machine.

Remove any tools.

Use manual feed to move the table

toward the front.

Shut down the modeling machine

and disconnect the power cable.

WARNING:

Be sure to disconnect

the power cable. Failure to do so

may result in danger of injury.



Gently turn the workpiece chuck by hand until the installation hole can be seen.

Slide the T-slot nut into the groove.

Attach the drive unit.



Slide the T-slot nut into the groove.

Attach the tailstock.

Stopper

Buttthisushagainst

the edge of the table.

Cap screw

(M8 x 20

mm)

T-slot nut

Tab

Buttthisushatthefront.

Cap screw

(M8 x 20 mm)

T-slot nut

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 79 80

Pas de commentaire

Roland AXIS-1 Manuel d'utilisateur Page 30