Roland LEC-540 Guide d'installation télécharger pdf (Page 52)

6. Installing the Blade

Install the blade holder.



Loosen the screw shown in the gure.



Support the screw from below and insert

the blade holder.

If installed without supporting the screw in this way,

cutting quality may become poor.

Tighten the screw.

Tug the blade holder upward to make sure it does

not come loose.



Close the front cover.

Press

Important Note on the Handling and Use of the Cutting Carriage

While the blade holder is not attached, leave the screws of the cutting carriage loose. If you leave them

tightened rmly, the hole to insert the blade holder is gradually getting smaller, which will make it dicult

to attach the blade holder.

Insert until the collar is

ush with the surface.

Support it from below.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

Pas de commentaire

Roland LEC-540 Guide d'installation Page 52