Roland UA-11 Manuel du propriétaire télécharger pdf (Page 11)

Introduction

Using Batteries

When using the DUO-CAPTURE EX with the [COMPUTER/TAB] switch (p. 10) set to “TAB,” three

alkaline batteries or commercially available rechargeable Ni-MH batteries (AA, LR6) are required.

Inserting the Batteries (Bottom Panel)

Tab

1. Remove the battery case cover on the bottom panel

of the DUO-CAPTURE EX.

While pressing the tab, lift the cover.

2. Insert the batteries into the battery case.

Make sure the “+” and “-” ends of the batteries are inserted in the

correct direction.

3. Close the battery case cover.

When removing the batteries, rst turn the DUO-CAPTURE EX

o, and then remove the battery case cover and remove the

batteries.

Note the following when using batteries

• Incorrect handling of batteries, rechargeable batteries, or a battery charger can cause leakage,

overheating, re, or explosion. Before use, you must read and strictly observe all of the precautions

that accompany the batteries, rechargeable batteries, or battery charger.

• If used improperly, batteries may explode or leak and cause damage or injury. In the interest of

safety, please read and observe the following precautions.

• Carefully follow the installation instructions for batteries, and make sure you observe the correct

polarity.

• Avoid using new batteries together with used ones. In addition, avoid mixing dierent types of

batteries.

• Remove the batteries whenever the unit is to remain unused for an extended period of time.

• Never keep batteries together with metallic objects such as ballpoint pens, necklaces, hairpins,

etc.

• Used batteries must be disposed of in compliance with whatever regulations for their safe

disposal that may be observed in the region in which you live.

• When operating this unit using batteries, please use alkaline batteries or rechargeable Ni-MH

batteries.

• This unit will not operate using batteries or bus power unless the AC adaptor is disconnected.

• Even if batteries are installed, the unit will turn o if you connect or disconnect the power cord from

the AC outlet while the unit is turned on, or if you connect or disconnect the AC adaptor from the

unit. You must turn o the power before you connect or disconnect the power cord or AC adaptor.

• The power will turn o shortly after the Power indicator has started blinking. At this point, you need

to change the batteries.

• The DUO-CAPTURE EX cannot be used to charge rechargeable Ni-MH batteries. Use a commercially

available battery charger.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Pas de commentaire

Roland UA-11 Manuel du propriétaire Page 11