Roland PC-600 Manuel d'utilisateur télécharger pdf (Page 56)

Chapter 3 - User's Reference

Cleaning the Main Unit

For routine cleaning, use a soft piece of cloth.

Cleaning the Platen

If the platen becomes soiled, wipe it clean with a dry, soft cloth.

Do not wipe with a head cleaner or alcohol.

Use care when cleaning to avoid damaging the surface of the platen. Printing quality may suffer.

If printing on the platen was performed by mistake

If the grime is allowed to remain, printing may be smudged or uneven. Follow the steps below to clean.

1) Apply cellophane tape over the soiling, then rub the tape with your finger.

2) Slowly peel off the tape.

Repeat until the grime is removed.

Lower the sheet loading lever.

If the material is not loaded at the correct location,

the SETUP LED flashs at the same time.

If this happens, reload the material at the proper

location.

When the front cover is closed, the BUSY LED

flashes and head cleaning starts.

Head cleaning is finished when the BUSY LED

goes dark.

10 11

Remove the material.

When cleaning is finished, open the front cover and

raise the sheet loading lever.

Switch off the sub power.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 64 65

Pas de commentaire

Roland PC-600 Manuel d'utilisateur Page 56