Roland PC-600 Manuel d'utilisateur télécharger pdf (Page 47)

Chapter 3 - User's Reference

Setting the Base Point

– Printing/Cutting at the Desired Location –

The BASE POINT key is used to set the base point for printing or cutting.

The base point can be set anywhere you like on the material, making it possible to print or cut unused portions of the material.

The base point can be set after finishing material setup (and lowering the sheet loading lever).

The base point remains enabled until you perform one of the operations described below.

- Raising the sheet loading lever

- Feeding the page

- Resetting the base point

- Pressing the [DATA CLEAR] key

- Pressing the [SHEET CUT] key

3-3 Other Functions

Open the front cover and use the cursor keys to move the carriage to a new base

point for printing or cutting. The BASE POINT setting can be only when in the

printing or cutting area. Take care to ensure that the front edge of the sheet does

not come loose from the front sensor.

< Example >

The center of the

blade mounted

on the cutting

carriage is set as

the origin point.

With the front cover left

open, hold down the [BASE

POINT] key until you hear a

beep.

NEW BASE POINT

The BASE POINT LED lights up

If the base point has been moved, enter the value for W

in the figure at right as the sheet size width for the driver.

If this value is not corrected, output results may be cut off

before reaching their normal end.

Rear

Front

NEW BASE POINT

Enter this value

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 64 65

Pas de commentaire

Roland PC-600 Manuel d'utilisateur Page 47