Roland PC-600 Manuel d'utilisateur télécharger pdf (Page 53)

Chapter 3 - User's Reference

How to Replace the Separating Knife

Make sure the power to the unit is

off before attempting to replace the

separating knife.

Doing so may result in injury.

Remove the separating knife.

Replace with a new knife.

Positioning groove

The knife is secured in place

by the magnet.

Install the separating knife.

1) Grasp the top portion of the holder and

slowly insert it into the groove.

* If the blade remains in the carriage, use the included

tweezers to remove it.

Do not pull

back while

doing this.

1) Remove the screw.

2) Grasp the top portion of the holder, and slowly pull it

out in the direction of the arrow.

Holder

2) Tighten the screw.

Take care to ensure

that the knife does

not slip.

Do not touch the tip of the blade

with your fingers.

Doing so may result in injury.

If the separating knife, replace it with the replacement blade included with the PC-600.

Follow the steps below to replace the blade.

Hold down the [POWER] key on the control panel

until the LED starts to flash, and switch off the sub

power.

Make sure the flashing POWER LED has gone out,

then switch off the main power.

Press the side of

the switch marked

with “

”.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 64 65

Pas de commentaire

Roland PC-600 Manuel d'utilisateur Page 53