Roland GR-20 Manuel du propriétaire télécharger pdf (Page 30)

Chapter 5 Connecting an External Sound Module or Sequencer

Local Control Off

The state in which the GR-20’s guitar control section is

internally connected to the sound generator is referred to as

“Local Control On.” In contrast, the Local Control Off setting

internally disconnects the GR-20’s sound generator from the

guitar control section, so that the sound generator will produce

sound only in response to MIDI messages from MIDI IN. The

guitar performance will be transmitted only from MIDI OUT.

fig.5-033(Local Control Off)

By selecting the Local Control Off setting and enabling the

“Soft Thru” setting on your externally connected sequencer,

you can avoid conflicts from occurring between the

performance data from your guitar and from the sequencer.

1. Turn off the GR-20, and then hold down the [SYSTEM

EDIT] button while turning the power on again.

The display will indicate “Lo” for approximately one

second, and the GR-20 will then enter Play mode.

fig.5-04(Local Off)

* The Local Control Off setting cannot be stored.

* If the connections between the GR-20 and your external MIDI

device form a loop, you must use the Local Control Off setting.

If you make connections with this setting On, switches will

not function, and the system will not operate correctly.

* To turn Local Control on, turn the power of the GR-20 off,

then on again.

GR-20

GK IN

MIDI IN

MIDI OUT

Guitar

Controller

Sequencer

Thru function to

MIDI OUT: On

MIDI OUT

Sound

Generator

Local Control

OFF

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Pas de commentaire

Roland GR-20 Manuel du propriétaire Page 30