Roland Fantom-S88 Manuel d'utilisateur télécharger pdf (Page 121)

121

Sampling

When you finish sampling, the sample will automatically be

added to the sample list. Press [SAMPLE LIST] to view the

sample list.

Samples you record will be lost when you turn off the

power. If you want to keep your sample, press [WRITE] to save

it (p. 134). Samples shown as “NEW” in the sample list have not

yet been saved.

fig.SMPL07_50

7. Press [EXIT] to go back to where you were before you

entered the Sampling screen.

Dividing a Sample During Sampling

1. During sampling, press [8 (Divide)].

The sample will be divided at the point where you pressed the

button, and the subsequent material will be sampled as a sample

of the next number.

* When sampling in mono, you can divide the material into a maximum

of 256 samples. When sampling in stereo, you can divide the material

into a maximum of 128 samples (L/R total 256 samples).

Sampling time

The Fantom-S contains 32 MB of memory, which allows about 6

minutes of mono or about 3 minutes of stereo sampling. If you

want to sample for a longer time than this, you must install

separately sold memory (DIMM) (p. 207).

Sampling Earlier in Time

(Skip Back Sampling)

Sometimes you may want to preserve a nice phrase that you

happened to play a bit earlier. In such cases, you can use the Skip

Back Sampling function to sample sounds that were played earlier in

time.

When you execute skip-back sampling, several beats of your prior

performance are saved as a sample. You can assign this sample to a

pad and play it from the pad.

fig.SMPL08

Button lit: Skip-back sampling can be performed in this

state.

Button unlit: Skip-back sampling cannot be performed.

Not operating. You cannot use skip-back

sampling if there is insufficient free memory.

Button blinking: The following screen will appear, and Skip

Back Sampling will be executed.

1. Press [SKIP BACK SAMPLING].

The following screen will appear, and Skip Back Sampling will

be executed.

fig.SMPL09_50

Sampling will stop automatically, and the Sample Edit screen

will appear.

From the Sample Edit screen you can press [3 (Sample Modify)]

to edit the sample (p. 129 and following). In addition, you can

press [6 (Assign KB/Pad)] and assign the sample to a part as a

patch (p. 127), or assign it to a pad (p. 126).

You can specify how far back sampling will occur when you

perform skip-back sampling (5–40 seconds). With the factory

settings this is set to 10 seconds.

If you want to keep the sample, perform the Save procedure (p.

134).

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 227 228

Commentaires sur ces manuels

Pas de commentaire

Roland Fantom-S88 Manuel d'utilisateur Page 121

Commentaires sur ces manuels

Produits connexes et manuels pour Les dispositifs de saisie Roland Fantom-S88