Roland DP-990 Manuel d'utilisateur télécharger pdf (Page 41)

Performing

The volume of the metronome can be adjusted, with 11 volume levels available.

fig.Panel-MetronomeVol-e.eps

While holding down the [Metronome] button, press the [-] or [+] button.

The display will indicate the metronome volume.

fig.d-5.eps

When the metronome volume is set to “0,” the metronome sound does not play.

A “count-in” is a count that is sounded before the song begins to play.

If you’re playing along with a song, you can sound a count to make it easier to

synchronize your own playing with the song.

fig.Panel-CountIn-e.eps

Press the [ ] button while the metronome is sounding.

A two-measure count sounds before the song plays.

A “count-down” is a count that is sounded at the end of the song’s introduction (before

you begin playing the keyboard) (p. 73).

Changing the Volume

Sounding a Count to Keep your Timing Accurate

DP-990_e.book 41 ページ２００９年２月１７日　火曜日　午前８時３０分

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 107 108

Pas de commentaire

Roland DP-990 Manuel d'utilisateur Page 41