Roland Jupiter 80 Manuel d'utilisateur télécharger pdf (Page 67)

Editing a Synth Tone

Introduction Playing Sounds Editing Sounds

Other Convenient

Functions

Connecting Other

Equipment

Appendix

• If a Synth Tone has been edited, a check mark (yellow) is shown

at the right of the tone name.

Volume and On/O Settings for Each

Partial

You can turn a Partial on/o by touching the <Partial SW>.

By touching <Partial SELECT> you can select the Partial that you

want to edit.

<Partial SW> Status

Lit red On

Unlit O

<Partial SELECT> Status

Lit green Selected

Unlit –

MEMO

• You can select two or more Partials by holding down the [SHIFT]

button and touching <Partial SELECT>.

• When the Synth Tone Edit screen is displayed, you can use the

PART BALANCE area of the panel to turn the three Partials on/o

and adjust their volume.

Turns each Partial

on/o.

Controls the AMP level

of each Partial.

The AMP level of each

Partial is shown by the

level meter.

• By holding down the [SHIFT] button and pressing the PART

[PERC ON/OFF], [LOWER ON/OFF], or [UPPER ON/OFF] buttons,

you can select the Partial that you want to edit.

PART button Selected Partial

PART [PERC ON/OFF] Partial 1

PART [LOWER ON/OFF] Partial 2

PART [UPPER ON/OFF] Partial 3

• To edit two or more Partials, simultaneously hold down the PART

buttons of the Partials that you want to edit.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 107 108

Pas de commentaire

Roland Jupiter 80 Manuel d'utilisateur Page 67