Roland XR-640 Guide d'installation télécharger pdf (Page 48)

6. Installing the Blade

Install the blade holder.



Loosen the screw of cutting carriage.

Support the screw from below and insert

the blade holder.

If installed without supporting the screw in this

way, cutting quality may become poor.

Tighten the screw.

Tug the blade holder upward to make sure it does

not come loose.

Close the front cover , press .

Important Note on the Handling and Use of the Cutting Carriage

While the blade holder is not attached, leave the screws of the cutting carriage loose. If you leave them

tightened rmly, the hole to insert the blade holder is gradually getting smaller, which will make it dicult

to attach the blade holder.

FINISHED?

Screw

Support it from below

Insert until the collar is

ush with the surface.

Screw

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Pas de commentaire

Roland XR-640 Guide d'installation Page 48