Roland Metaza MPX-80 Manuel d'utilisateur télécharger pdf (Page 43)

Chapter 3 Making Prints

3-2 Getting Ready

Loading Material Using the Center Vise

Procedure



Switch on the power.

 P.30, "Switching On the Power"



Make sure that the knob is tight-

ened in the state shown in the

gure.

If it is not in the state shown in the gure,

loosen the knob, and then tighten it as

it is in the state shown in the gure. To

loosen the knob, rotate it counterclock-

wise once.



Attach a head cap to the tip of

head.

Mount the head as lightly holding it as

shown in the gure. The head cap is at-

tached correctly when its tab clicks.



Load the material.

Clamp the material in place in the vise,

and tighten the retaining screw enough

to keep the material from easily coming

loose. Be careful not to overtighten,

because doing so may damage the

material.

Loosen

Tighten

Retaining

screw

Tighten

Ring

Stopper

Knob

The center of the knob must

be positioned above this

marking.

Head cap

Head

Hold the head.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 119 120

Commentaires sur ces manuels

Pas de commentaire

Roland Metaza MPX-80 Manuel d'utilisateur Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Roland Metaza MPX-80